Section 8 - General Specifications & Operator Maintenance; Introduction; Operating Specifications - JLG TOUCAN 1010I Operation And Safety Manual

SECTION 8. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
8.1

INTRODUCTION

This section of the manual provides additional
necessary information to the operator for proper
operation and maintenance of this machine.
The maintenance portion of this section is intended as
information to assist the machine operator to perform
daily maintenance tasks only, and does not replace the
more thorough Preventive Maintenance and Inspection
Maximum Work Load
Slewing
Max. Platform Height
Horizontal Reach
(from centerline of machine)
(from rear wheel edge)
(from side wheel edge)
Up and Over Clearance
Max. Hydraulic System Pressure
Maximum Operating Wind Speed
Maximum Horizontal Manual Force
Electrical System Voltage
Gross Machine Weight
(Platform Empty)
Gross Machine Weight
(Platform Empty)
Overall Length
Overall Height
Overall Width
Maximum Wheel Load
Maximum Travel Grade (Gradeability)
With mast in stowed position and jib below horizontal
Maximum Travel Grade (Side slope)
With mast in stowed position and jib below horizontal
Tilt Sensor Setting
Turning Radius
Inside :
Mast raised up to 2m
Raised
Outside :
Mast raised up to 2m
Raised
Vibration levels
Acoustic pressure
31210005
SECTION 8 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
Table 8-1. Operating Specifications And Dimensions
before 2010
since 2010
The weighed root mean square acceleration value to which the arms are subjected
(control levers) is inferior to 2.5m/s/s.
The weighed root mean square acceleration value to which the feet are subjected (plat-
form floor) is inferior to 0.5m/s/s/.
The equivalent continuous 'A' weighed sound pressure level at the work station is <to
70 dB(A).
The measure has been taken by placing the sonometer at 1.60m above the platform
floor.
Schedule included in the Service and Maintenance
Manual.
Other Publications Available :
Service and Maintenance Manual .................... MA0235
Illustrated Parts Manual ..................................31210057
8.2

OPERATING SPECIFICATIONS

T1010
Basket
700 x 900 mm 1010 x 900 mm
200 kg (2 persons + 40 kg material)
360° non-continuous
2.76 m
1.89 m
2.26 m
45 km/h (12.5 m/s)
3300 kg
3450 kg
2.90 m
0.99 m
2200 kg
– JLG Lift –
Basket
8.10 m
3.08 m
2.21 m
2.58 m
6.47 m
23 MPa
400 N
24V
3.23 m
1.99 m
20% (11°)
5°
2°
0
1.78 m
1.75 m
3.37 m
T1010I
2.76 m
1.89 m
2.22 m
0 km/h
2650 kg
2.90 m
1.06 m
1900 kg
8-1