4.11 Skyguard Operation; Oscillating Axle Lockout Test (If Equipped) - JLG E600 Operation And Safety Manual

SECTION 4 - MACHINE OPERATION

4.11 SKYGUARD OPERATION

Skyguard is used to provide enhanced control panel protection.
When the SkyGuard sensor is activated, functions that were in
use at the time of actuation will reverse or cutout. The table
below outlines these functions.
Table 4-1. Skyguard Function Table
Main Main Drive
Swing
Lift Tele Forward Reverse
R C/R* R R I
R = Indicates Reversal is Activated
C = Indicates Cutout is Activated
I = Input is Ignored
Note: When Soft Touch is enabled with SkyGuard all functions are cut out only.
* Reversal only applies to Main Tele Out. Main Tele In would be cut out
4-10
Drive Platform Platform Jib
Level Rotate Lift
R R C C C

4.12 OSCILLATING AXLE LOCKOUT TEST (IF EQUIPPED)

LOCKOUT SYSTEM TEST MUST BE PERFORMED QUARTERLY, ANY TIME A SYSTEM COM-
PONENT IS REPLACED, OR WHEN IMPROPER SYSTEM OPERATION IS SUSPECTED.
Refer to Section 6.4, Oscillating Axle Lockout Test (If Equipped) for
procedure.
Jib Jib
Rotate Tele
C C
– JLG Lift – 3121217