JLG E600 Operation And Safety Manual page 47

8. Battery Indicator and Hourmeter
An hourmeter is installed in the upper portion of the Ground
Control Box. The hourmeter registers up to 9,999.9 hours
and cannot be reset.
9. Generator Enabled Indicator
The generator enabled indicator lights to signify the genera-
tor is enabled and may start at any time as the batteries
require. If the indicator flashes, it signifies an abnormal con-
dition for the generator engine (high oil temperature or low
oil pressure) or, on all electric machines, an electrical system
fault.
NOTE: Refer to the Service Manual for the generator fault codes.
10. Generator/Engine Start Button (if equipped)
The generator/engine start push-button switch allows the
generator to be started manually to top-off the battery
charge. The generator will start automatically when the bat-
teries reach a low-charge level.
3121217
SECTION 3 - MACHINE CONTROLS AND INDICATORS
11. Articulating Jib Boom (If Equipped)
This switch provides raising and lowering of the jib.
12. Jib Rotate (If Equipped)
A three position switch permits rotation of the jib and plat-
form.
13. Platform Overload (If Equipped)
Indicates the platform has been overloaded.
14. Function Enable (If Equipped)
If equipped, the enable switch must be held "DOWN" to
enable all boom controls when the engine is running.
– JLG Lift – 3-7