Table of Contents
Advertisement
Quasar CB-6204/CB-6208 User and Installation Guide
notifications by the IO event triggered. When an alarm is triggered, the notification will be
sent to one of two specified HTTP servers. See figure below.
Record video clip – Select this box in order to save the alarm-triggered recording to your
microSDXC card or to the NAS. Enter the number of seconds for the pre-trigger buffer. Select
the first radial button if you wish to upload for a specified length of time and enter the
number of seconds. Alternatively, select the second radial button to upload during the active
trigger.
Note:
In order to use this function, make sure that local recording with a microSDXC
card is activated and that the NAS is properly configured. See
further details.
Send message by E-Mail – Select the checkbox send an alarm message by e-mail when an
alarm is triggered. The e-mail address is entered in the
Upload image by E-Mail – Select this checkbox to assign an e-mail address for sending the
image captured by a triggered alarm. The e-mail address is entered in the
Note:
Images can be sent by e-mail only when MJPEG is selected as the video stream
from the
From the E-Mail address drop-down list, select one of the two e-mail addresses.
From the Pre-trigger buffer and Post-trigger buffer drop-down lists, select the number
of frames for the buffer from 1-20 frames.
Check the Continue image upload box if you wish to upload an image by e-mail for a
defined period of time or while the trigger is active. Select one of the following options:
To specify the length of time for the upload, select Upload for and enter the
number of seconds in the text box.
To upload while the trigger is active, select Upload while the trigger is active.
54
Figure 54: Send HTTP Notification
Figure 55: Record Video Clip
Video Format
screen.
Figure 56: Upload Image by E-Mail
Recording
Mail
screen.
Mail
for
screen.
Hide quick links:
Advertisement
Table of Contents
