Power And Ethernet Cable Connection; Initial Camera Configuration; Figure 14: Discovered Ip Devices - Quasar CB-6204 User And Installation Manual

Quasar CB-6204/CB-6208 User and Installation Guide

5.3 Power and Ethernet Cable Connection

Make sure the camera's power cable is properly connected. Refer to
using Power over Ethernet (PoE), make sure Power Sourcing Equipment (PSE) is available on the
connected network. All electrical work must be performed in accordance with local regulatory
requirements.

5.4 Initial Camera Configuration

To perform the initial camera configuration
1. Unpack the camera.
2. Connect one end of the network Cat 5 Ethernet cable to the RJ45 connector on the camera's
system cable.
3. Connect the other end of the network cable to a Power Sourcing Equipment (PSE) device,
such as a switch.
4. Verify that the LEDs on the RJ45 connector illuminate green (indicating a stable network
connection) and flashing yellow (to indicate network activity).
5. Do the following:
a. Copy and run dna.exe (see note below) from the included CD.
b. Click the
c. Select the unit requiring IP assignment.
d. Right-click the mouse and select the assigned IP address or click the Assign IP button
to open the DNA Assign IP dialog box.
e. In the dialog box that is displayed, enter values for the IP Address, Gateway and
Netmask.
f. Click Update and wait for
14
Note:
DNA is an enhanced software alternative to Device Search. Either of these
programs may be used. They are supplied on the included CD.
icon.

Figure 14: Discovered IP Devices

Note:
The camera default IP Address and the subnet mask IP Address are
automatically supplied by the DHCP server.
OK status to be displayed.
System Cable Connectors. If