Quasar CB-6204 User And Installation Manual page 72

 Record video clip – Select this box in order to save the alarm-triggered recording into a
microSDXC card. Enter the number of seconds for the pre-trigger buffer. Select the first
radial button to upload for a specified length of time and enter the number of seconds.
Alternatively, select the second radial button to upload during the active trigger. See
Figure 55: Record Video Clip.
Note:
In order for this function to be implemented, make sure that local recording
with a microSDXC card is activated and that the NAS is properly configured.
See
 Send message by E-Mail – The Administrator can select whether to send an alarm
message by e-mail when tampering is detected.
 Upload Image by E-Mail – Selecting this option enables you to assign an e-mail address
and configure various parameters, as shown in Figure 56: Upload Image by E-Mail. When
tampering is detected, event images will be sent to the designated e-mail address.
Note:
Images can be sent by e-mail only when MJPEG is selected as the video stream
from the
Select one of two e-mail addresses from the drop-down menu. Select the number of
frames for the pre-trigger and post-trigger buffers from the drop-down menu of 1-20
frames.
Check the box for Continue image upload if you wish to use this option. To specify the
length of time for the upload, click this radial button and enter the number of seconds. To
upload while the trigger is active, click this radial button. Finally, select the number of
frames per second from the drop-down menu next to Image frequency.
Note:
Make sure SMTP or FTP configuration has been completed. See the
sections for further details.
9.3.4.3.4 File Name

File Name – Enter a file name in the field, for example image.jpg. The uploaded image's file
name format is set in this section. Select one that meets your requirements.

Add date/time suffix (default setting)
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
H: Hour, N: Minute, S: Second
X: Sequence Number

Add sequence number suffix (no maximum value)
File name: imageXXXXXXX.jpg
X: Sequence Number

Add sequence number suffix (limited value)
File Name: imageXX.jpg
X: Sequence Number
The file name suffix ends at the number being set. For example, if the setting is up to "10,"
the file name will start from 00, end at 10, and then start over again.
Recording for further details.
Video Format screen.
Configuration and Operation
Mail and FTP
59