Quasar CB-6204 User And Installation Manual page 77

Quasar CB-6204/CB-6208 User and Installation Guide
Finally, select the number of frames per second from the drop-down menu next to Image
frequency.
 Send HTTP notification – Check this option, select the destination HTTP address, and
specify the parameters for HTTP notifications. When an alarm is triggered, the HTTP
notifications can be sent to the specified HTTP server. See Figure 54: Send HTTP
Notification.
 IR Cut Filter – Select this checkbox to trigger an event when the IR cut filter is activated.
From the drop-down menu, select on or off. When the IR Cut filter is set to on, the IR LED
illuminator is activated for use in low-light environments in which Night mode is normally
used.
 Send message by E-Mail – The Administrator can select whether to send an alarm
message by e-mail when an alarm is triggered.
 Upload Image by E-Mail – Selecting this option enables you to assign an e-mail address
and configure various parameters, as shown in Figure 56: Upload Image by E-Mail. When
an alarm is triggered, event images will be sent to the designated e-mail address.
Note:
Images can be sent by e-mail only when MJPEG is selected as the video stream
from the
Select one of two e-mail addresses from the drop-down menu. Select the number of
frames for the pre-trigger and post-trigger buffers from the drop-down menu of 1-20
frames.
Check the box for Continue image upload if you wish to use this option. To specify the
length of time for the upload, click this radial button and enter the number of seconds. To
upload during the active trigger, click this radial button. Finally, select the number of
frames per second from the drop-down menu next to Image frequency.
Note:
Make sure SMTP or FTP configuration has been completed. See the
FTP
 Record video clip – Select this box in order to save the alarm-triggered recording into a
microSDXC card. Enter the number of seconds for the pre-trigger buffer. Select the first
radial button to upload for a specified length of time and enter the number of seconds.
Alternatively, select the second radial button to upload during the active trigger. See
Figure 55: Record Video Clip.
Note:
To implement function, make sure that local recording with a microSDXC card
is activated and that the NAS is properly configured. See
9.3.4.6.3 File Name

File Name – Enter a file name in the field, for example image.jpg. The uploaded image's file
name format is set in this section. Select one that meets your requirements.

Add date/time suffix (default setting)
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
H: Hour, N: Minute, S: Second
X: Sequence Number
64
Video Format screen.
sections for further details.
Mail and
Recording for details.