Internal Connectors; System Cable Connectors; Figure 4: Microsd Card Drive And Reset Button; Figure 5: Cb-620X Camera Input/Output Connections - Quasar CB-6204 User And Installation Manual

Ip bullet camera

Table of Contents

3.3 Internal Connectors

The camera's microSD card drive and reset button are inside the camera housing.

Note:

1. Desiccant is included inside the camera housing and must be replaced every time the

housing is opened. After desiccants are replaced, reconnect the front housing to the

camera as soon as possible. Otherwise, the desiccant will become damp and cannot be

used. For instructions on removing the desiccant, refer to the Desiccant User Guide.

To perform a hard reset to full factory defaults using the Reset button

1. Press a pointed object against the black switch on the Reset button.

2. Press the button for 30 seconds. Both LEDs on the RJ45 connector are extinguished. After

one second, the green network LED flashes once and remains lighted. The yellow activity

LED flashes as soon as it detects network activity. The unit returns to full factory defaults.

The camera is shipped with a system cable for network, power, I/O, and audio connections. The

figure below shows the various connectors included in the system cable of the camera. The

connectors, pin numbers and signal definitions are listed below.

Introduction to the CB-620x IP Bullet Camera

Table of Contents

Show Quick Links

Table of Contents

Cb-6208