Mounting The Camera - Quasar CB-6204 User And Installation Manual

Quasar CB-6204/CB-6208 User and Installation Guide

5.5.2 Mounting the Camera

To mount the camera, follow one of these procedures:

For indoor/outdoor installations:
a. On the ceiling/wall/flat surface, install a security camera wall mount bracket stand
that is sturdy enough to hold the camera in a fixed position for the field of view
required.
b. Screw the bracket/stand to the mounting socket on the bottom of the camera.
c. Connect the system cable to the network, power, I/O devices, and audio devices, as
required for your site. See

For bracket, pole and pendant installations:
a. Feed the system cable through the mounting accessory.
b. Check that the installation is not flimsy, will not wobble, and is flush with the
mounting surface.
c. Plug the network Cat 5 cable into the camera's Ethernet port.
d. Do one of the following:

If using an external power supply, plug the power terminal block into the power
supply terminals.

If using PoE, connect the other end of the Cat 5 cable to the network and turn on
the power from the power supply.
e. If applicable, wire the Alarm In, Alarm Out, Audio In, and Audio Out terminal blocks
to external devices.
16
System Cable Connectors
Note:
The power cable is not required if using PoE.
Tip:
Even if you are not using alarm inputs and audio input/output at the time of
installation, you may want to consider pre-wiring these connections for
future use. Use shims for shoring up mounts on uneven surfaces.
(page 5).