Figure 72: Motion Window With Detection; Figure 73: Pixel Interval Illustration - Quasar CB-6204 User And Installation Manual

When motion is detected, the signals are displayed in the Motion window shown below.
Detailed settings for motion detection are as follows:

Sampling pixel interval [1-10] – Select a number from 1-10. The default value is 1. If the
value is set as 3, within the detection region, the system will take one sampling pixel for
every 3 pixels by each row and each column (see the figure below).

Detection level [1-100] – Select a number from 1-100. The default level is 40. This sets
detection level for each sampling pixel; the smaller the value, the more sensitive it is.

Sensitivity level [1-100] – Select a number from 1-100. The default level is 80, which means if
20% or more sampling pixels are detected differently, the system will detect motion. The
bigger the value, the more sensitive it is. When the value is bigger, the red horizontal line in
the motion indication window will be lowered accordingly.

Time interval (sec) [0-7200] – Select a number from 0-7200 (seconds). The default interval is
10. The value is the interval between each detected motion.
Triggered Action
The Administrator can specify alarm actions to be taken when motion is detected. See Figure 69:
Motion Detection Screen. The options are listed as follows:

Enable alarm output – Check this box and select the predefined type of alarm output (low or
high) to enable alarm relay when tampering is detected.

Record video clip – Select this box to store the motion detection alarm recording in a
microSDXC card or on the NAS when tampering is detected. Enter the number of seconds for
the pre-trigger buffer. Select the first radial button to upload for a specified length of time
and enter the number of seconds. Alternatively, select the second radial button to upload
during the active trigger.
Note:
Make sure the local recording (with microSDXC card) is activated so that this
function can be implemented. See

Send alarm message by FTP – Select whether to send an alarm message by FTP when motion
is detected.

Figure 72: Motion Window with Detection

Figure 73: Pixel Interval Illustration

Recording
Configuration and Operation
for further details.
73