Figure 44: Upload Image By E-Mail; Figure 45: Send Http Notification; Figure 46: Record Stream To Sd Card - Quasar CM-4321 User And Installation Manual

CM-4321 User and Installation Guide

Upload Image by E-Mail – Select this box in order to assign an e-mail address and configure
various parameters. See figure below. When motion is detected, event images are sent to one
of two designated e-mail addresses. Select the number of frames for the pre-trigger and post-
trigger buffers from the drop-down menu of 1-20 frames.
Check the box for Continue image upload to use this option. To specify the length of time for
the upload, click on this radial button and enter the number of seconds. To upload during the
active trigger, click on this radial button. Finally, select the number of frames per second from
the drop-down menu next to Image Frequency.
Note:
Make sure that SMTP or FTP configuration has been completed. See
further details.

Send HTTP notification – Check this box to send a notification by HTTP. Select the destination
HTTP address from the drop-down menu and specify the parameters for event notifications by
motion detection triggered. When an alarm is triggered, the notification will be sent to one of
two specified HTTP servers.

Record stream to sd card – Select this box to store the motion detection alarm recording in a
microSD/SDHC card when tampering is detected. Enter the number of seconds for the pre-
trigger buffer. Select the first radial button to upload for a specified length of time and enter
the number of seconds. Alternatively, select the second radial button to upload during the
active trigger.
Note:
Make sure the local recording (with microSD/SDHC card) is activated so that this
function can be implemented. See
42

Figure 44: Upload Image by E-Mail

Figure 45: Send HTTP Notification

Figure 46: Record Stream to SD Card

Recording
Mail
for further details.
and FTP for