Configuring Communication Settings On The Quasar Camera; Figure 19: Windows Firewall Screen; Figure 20: Discovered Ip Devices - Quasar CB-6204 User And Installation Manual

7 Configuring Communication Settings on the Quasar Camera

To configure communication settings on the camera
1. Connect the camera to the network on the same VLAN/LAN as the workstation.
2. If the network supports the default, open the DNA utility by running dna.exe which can be
found in the DNA Utility folder in the supplied CD, or click the DNA icon
Note:
DNA is an alternative software to Device Search. Either of these programs may be
used.
3. In the DNA application, click the DNA button.
4. If the Windows Firewall is enabled, a security alert window pops up.
5. To continue, click Allow Access. Latitude users should consult the Latitude Installation
Instructions on disabling the Windows Firewall.
6. Click Assign IP. All the discovered IP devices will be listed in the page, as shown in the figure
below. The camera's default IP Address is automatically supplied by the DHCP server.
Configuring Communication Settings on the Quasar Camera

Figure 19: Windows Firewall Screen

Figure 20: Discovered IP Devices

.
21