Quasar CB-6204 User And Installation Manual page 59

Quasar CB-6204/CB-6208 User and Installation Guide
To enable the SNMP v3 protocol, enter the appropriate data and passwords requested:

Enable SNMP v3 – Select the checkbox.

Security Name – See note below.

Authentication Type – Select MD5 or SHA from the drop-down list. See note below.

Authentication Password – See note below.

Encryption Type – Select DES or AES from the drop-down list. See note below.

Encryption Password – See note below.
Note:
You may have to consult with your System Administrator to activate this function.
Traps for SNMP v1/v2/v3
Traps are used by the camera to send messages to a management system for important events or
status changes.

Enable traps – Check this box to activate trap reporting.

Trap address – Enter the IP address of the management server.

Trap community – Enter the community to use when sending a trap message to the
management system. The default value is public.

Trap Option

Warm start – A warm start SNMP trap signifies that the SNMP device, such as the
camera, performs a software reload.
Click SAVE when complete.
46