5.5.3 Installing the Camera
To install the camera
1. Place the camera at the installation location.
2. Place the supplied template on the surface where you will install the camera.
3. On the ceiling or wall, mark the position of the two screw holes on the base of the mounting
bracket.
4. At the center of the marked holes, draw a cable entry hole with 30 mm (1.2") diameter/15
mm (0.6") radius.
5. Drill the cable entry hole.
6. Drill a hole slightly smaller than the supplied plastic screw anchor on each marked screw
hole.
7. Insert the plastic screw anchors into the drilled holes.
8. Thread the camera's system cable through the cable entry hole. Refer to
Connectors
(page 5) for cable connections.
9. Match the screw holes of the camera with the plastic screw anchors at the installation
location.
10. Fasten the camera with the supplied M4x31 self-tapping screws.
11. Loosen the screw circled below in order to rotate the camera at the base.
Figure 16: Screw Holes on Mounting Base
Figure 17: Mounting Base Rotation Screw
Installation
System Cable
17