Waterproofing The Camera Cable Connectors; Figure 6: Camera Cables; Figure 7: System Cable - Quasar CB-6204 User And Installation Manual

Quasar CB-6204/CB-6208 User and Installation Guide
No. Cable
1 RJ45
Power (DC 12V*/AC 24V)
2
(3-pin Terminal Block)
Alarm I/O
3
(4-pin Terminal Block)
4 Audio I/O
5 BNC

3.4.1 Waterproofing the Camera Cable Connectors

Follow the instructions below to waterproof the connectors for the different types of cables included
in the system cable. The cables are shown below.
System Cable
3.4.1.1 System Cable
To waterproof the system cable
1. Connect all the required devices to the system cable.
2. Coat the joints with silicone gel. There should be no gap between the connectors and the
cables. For alarm I/O connector and power connector, make sure the side with wires
attached is also sealed with silicone gel.
6
Pin Definition
For network and PoE
-
connections
1 DC 12V − AC 24V 1
2 Reserved GND
3 DC 12V + AC 24V 2
1 Alarm In −
2 Alarm In +
3 Alarm Out −
4 Alarm Out +
Green Audio Out
Pink Audio-in/Mic-in
- For analog video output
RJ45 Cable

Figure 6: Camera Cables

Figure 7: System Cable

Remarks
Power connection
Alarm connection
Two-way audio transmission
IP66 RJ45 Cable