Quasar CB-6204 User And Installation Manual page 11

Quasar CB-6204/CB-6208 User and Installation Guide
Electrical Safety Notice and Warnings
Warning:
1. Read the installation instructions before you connect the unit to a power source.
2. Electrical safety should always be observed. All electrical connections must be
performed by a certified electrician.
3. Use the supplied power supply and protect against static electricity, ground faults
and power surges.
4. The unit uses a three-wire power cord to make sure that the product is properly
grounded when in use. This is a safety feature. If the intended power outlet does
not support three prongs, one of which is a ground, contact an electrician to install
the appropriate outlet. NEVER remove or otherwise attempt to bypass the ground
pin of the power cord. Do not operate the unit in the absence of a suitably
installed ground conductor.
5. If you use an extension cord with this system, make sure that the total ampere
rating on the products plugged into the extension cord does not exceed the
extension cord ampere rating.
6. To avoid possible shock hazards or damaging the unit, assure that the positive and
negative of the power leads are properly connected to the terminal block
connector before plugging it into the unit or turning on the power source.
7. In the following situations, the electric power should be turned off immediately
and appropriate repairs, replacements or remedies should be taken if:

The power line is damaged, frayed or shows heavy wear.

The unit has been physically crushed or deformed.

The unit has been exposed to water.

The unit has been exposed to, or shows signs of damage from, fire, intense
heat, heavy smoke, fumes, or vapors.

Electrical connections of the unit become abnormally hot or generate smoke.

The unit has been dropped, damaged or shows signs of loose internal parts.

The unit does not operate properly.
x