Mounting The Cm-4251-10-I Indoor Camera; Figure 10: Base Plate Used As A Template To Mark Drilling Locations - Quasar CM-4251 Series User And Installation Manual

5.6.2 Mounting the CM-4251-10-I Indoor Camera

1. Do one of the following:

For drilled wall or ceiling mounting:
a) Use the base plate as a template, mark with a pointed pencil, the mounting surface
through the plate holes where the four screw holes will need to be drilled
(see Figure 10).
Caution:
Before marking and drilling the holes, ensure that the base plate alignment is oriented
correctly so that the required camera field of view can be achieved when the system is
assembled.

Figure 10: Base Plate Used as a Template to Mark Drilling Locations

b) In the marked locations, drill each hole using a drill-bit of a slightly smaller diameter
than the supplied screw anchors (molly-plug anchor). You want to achieve a snug
insertion so that the plug expansion holds firm after the screws are screwed in.
c) Fully insert the supplied anchors into drilled holes. You may need to tap them flush
with the wall using a hammer.
• For installing on a 4S recessed electrical box:
a) Have a qualified installer (check your local electrical codes) rough-in the 4S recessed
electrical box and run the wires and power (if not PoE) through the wall/conduits to
the box location.
b) Ensure that the box is sufficiently sturdy (attach to the wall stud, ceiling joist, or
reinforced surface as needed) to securely hold the weight of the camera.
• For bracket, pole and pendant installations, follow the hanging device installation
instructions.
2. If running the cables through the back, thread the power and Ethernet cables and any other
wires (such as a relay output, alarm input, audio in, or audio out) through the back wire
entry. If you are not wiring from within the wall, you can run the wires through the slot on
the side of the Mini-Dome. Punch out the half circle slot and run the wires through this slot.
Installation
13