Ricoh M5 Service Manual page 80

Follow steps 1 through 6 of Exposure Lamp Replacement.
1 .
2 . Remove the accuride rail (3 screws).
Remove the pulse generator bracket (1screw).
3 .
4 . Take off the slider clutch bracket (3 screws) and unhook the slider stopper spring from the
bracket. (Do not break the slider stopper pin.
5 . Remove slider drive gear.
Take off the rear exposure lamp terminal (1 small screw).
6 .
7 . Disconnect the 2P connector on the ac drive board.
8 . Remove exposure lamp heater.
NOTE: 1. When installing the new exposure lamp heater, use the old spring.
2. After reassembling, make sure the slider stopper spring and pin are securely
mounted.
(See page 3-22.)
3 - 2 3
25, 1985
May,
Slider Drive Gear
Slider Clutch Bracket
Pulse Generator
Bracket
2P Connector
/