Pressure Roller - Ricoh M5 Service Manual

– Pressure Roller –
.-. "
1. Follow steps 1 through
2. Remove the fusing lower guide (3 screws).
3.
Remove the pressure roller gear (1 E-ring).
4. Remove the pressure roller and two bushings (2 E-rings).
5. Carefully install a new pressure roller.
NOTE: 1. Before reinstalling the hot roller, check that the spring anchors are positioned as
shown.
2. Be careful not to damage the pressure and hot rollers.
3. Make sure both ends
8 of the
Hot Roller Replacement.
of the
fusing lamp properly contact the terminals
3 - 7 2

Pressure Roller

(See
page
25, 1985
May,
3-71.)