IMAGE TRANSFER AND SEPARATION
1. Image Transfer
The relay rollers feed the copy paper through the transfer entrance guides to the transfer section. A
high negative voltage is applied to the transfer corona wire, and as a result the corona wire generates
a cloud of negative ions.
attracts the positively charged toner away from the master and onto the paper.
If damp paper is used, it will reduce the efficiency of transfer.
paper is lower than that of dry paper.
So, part of the transfer corona charge may leak to the machine ground or across the paper to the
master.
This will reduce the effectiveness of the transfer process which results
image.
2. Paper Separation
There is no separation mechanism.
just after the transfer point.
ates without any assistance.
These negative
ions are applied to the copy paper, and the negative charge
The master turns at a sharp angle (approximately 90 degrees)
Due to the paper's stiffness, it
Master Belt
The electrical resistance of damp
cannot make this sharp turn and separ-
3 - 4 2
May, 25, 1985
or patchy
in a light