Ricoh M5 Service Manual page 138

Remove the front and rear covers.
1 .
a block in front of the exit cover.
2 . Place
NOTE: This block must have a height of approximately 50 mm (2").
Raise the upper clamshell part way and
3 .
Rear)
Carefully lower the upper clamshell onto the block.
4 .
NOTE: When installing the stud screws, check that both torsion bars are installed correctly.
(See page
3-79.)
remove the two stud screws from
3 - 8 0
May, 25, 1985
Torsion Bar
the hinge. (Front and