AudioCodes Mediant 3000 User Manual page 336

Parameter
Web: Tel Profile Settings Table
EMS: Telephony Profile
[TelProfile]
SIP User's Manual
The parameter CallLimit defines the maximum number of concurrent
calls allowed for that Profile. If the Profile is set to some limit, the
device maintains the number of concurrent calls (incoming and
outgoing) pertaining to the specific Profile. A limit value of [-1]
indicates that there is no limitation on calls (default). A limit value of
[0] indicates that all calls are rejected. When the number of
concurrent calls is equal to the limit, the device rejects any new
incoming and outgoing calls pertaining to that profile.
RxDTMFOption configures the received DTMF negotiation method: [-
1] not configured, use the global parameter; [0] don't declare RFC
2833; [1] declare RFC 2833 payload type is SDP.
FirstTxDtmfOption and SecondTxDtmfOption configures the transmit
DTMF negotiation method: [-1] not configured, use the global
parameter; for the remaining options, refer to the global parameter.
IP Profiles can also be used when operating with a Proxy server (set
the parameter AlwaysUseRouteTable to 1).
For a detailed description of each parameter, refer to its
corresponding global parameter.
For a description of using ini file table parameters, refer to ''Format of
ini File Table Parameters'' on page 221.
This ini file table parameter configures the Tel Profile table. Each Tel
Profile ID includes a set of parameters (which are typically configured
separately using their individual, "global" parameters). You can assign
these Tel Profile IDs to the Trunk Group table (TrunkGroup
parameter).Therefore, Tel Profiles allow you to easily apply different
behaviors (parameter settings) to different channels.
The format of this parameter is as follows:
[TelProfile]
FORMAT TelProfile_Index = TelProfile_ProfileName,
TelProfile_TelPreference, TelProfile_CodersGroupID,
TelProfile_IsFaxUsed*, TelProfile_JitterBufMinDelay*,
TelProfile_JitterBufOptFactor*, TelProfile_IPDiffServ*,
TelProfile_SigIPDiffServ*, TelProfile_DtmfVolume,
TelProfile_InputGain, TelProfile_VoiceVolume,
TelProfile_EnableReversePolarity,
TelProfile_EnableCurrentDisconnect, TelProfile_EnableDigitDelivery,
TelProfile_EnableEC, TelProfile_MWIAnalog, TelProfile_MWIDisplay,
TelProfile_FlashHookPeriod, TelProfile_EnableEarlyMedia*,
TelProfile_ProgressIndicator2IP*, TelProfile_TimeForReorderTone*,
TelProfile_EnableDIDWink, TelProfile_IsTwoStageDial,
TelProfile_DisconnectOnBusyTone,
TelProfile_EnableVoiceMailDelay,TelProfile_DialPlanIndex;
[\TelProfile]
For example:
TelProfile 3 = ITSP_acme, 1, 0, $$, $$, 10, 46, 40, -11, 0, 0, 1, 0, 0, 1, 0,
0, 700, 0, -1, 255, 0, 1, 1, 1, -1;
Notes:
You can configure up to nine Tel Profiles (i.e., indices 1 through 9).
The following parameters are not applicable: EnableReversePolarity,
EnableCurrentDisconnect, MWIAnalog, MWIDisplay, EnableDIDWink,
336
Description
Document #: LTRT-89707
Mediant 3000