Figure 3-80: Inbound Ip Routing Table - AudioCodes Mediant 3000 User Manual

3.3.7.9.5 Configuring the Inbound IP Routing Table
The 'Inbound IP Routing Table' page allows you to identify received calls as inbound IP-to-
IP calls and assign them to an IP Group (defined in ''Configuring the IP Groups'' on page
120), termed the Source IP Group. This table identifies these IP calls based on any
combination of the following criteria rules:
Destination and source host prefixes
Destination and source telephone number prefixes
Source IP address
Assigning these IP calls to Trunk Group ID '-1' identifies them as inbound IP-to-IP calls.
These calls, now pertaining to an IP Group, can later be routed to an outbound destination
IP Group (refer to ''Configuring the Outbound IP Routing Table'' on page 156).
Note:
To configure Inbound Routing:
1. Open the 'Inbound IP Routing Table' page (Configuration tab > Protocol
Configuration menu > Routing Tables submenu > IP to Trunk Group Routing page
item).
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
add.
3. Configure the table according to the table below.
4. Click the Submit button to save your changes.
5. To save the changes so they are available after a power fail, refer to ''Saving
Configuration'' on page 190.
SIP User's Manual
The 'Inbound IP Routing Table' page appears only if the IP2IP application is
enabled; otherwise, the 'IP to Trunk Group Routing Table' page appears
instead (refer to ''Configuring the IP to Trunk Group Routing Table'' on page
159).

Figure 3-80: Inbound IP Routing Table

162
Mediant 3000
Document #: LTRT-89707