AudioCodes Mediant 3000 User Manual page 388
Hide thumbs
Also See for Mediant 3000:
- User manual (1070 pages) ,
- Installation manual (90 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
Parameter
Web: DTMF Min Detection Time
[CasStateMachineDTMFMinOn
DetectionTime]
Web: MAX Incoming Address
Digits
[CasStateMachineMaxNumOfI
ncomingAddressDigits]
Web: MAX Incoming ANI Digits
[CasStateMachineMaxNumOfI
ncomingANIDigits]
Web: Collect ANI
[CasStateMachineCollectANI]
Web: Digit Signaling System
[CasStateMachineDigitSignalin
gSystem]
[CASSendHookFlash]
SIP User's Manual
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be
longer than this value to receive a detection. Any number may be
used, but the value must be less than
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default value is -1.
Defines the limitation for the maximum address digits that need to
be collected. After reaching this number of digits, the collection of
address digits is stopped.
The value must be an integer. The default value is -1.
Defines the limitation for the maximum ANI digits that need to be
collected. After reaching this number of digits, the collection of
ANI digits is stopped.
The value must be an integer. The default value is -1.
In some cases, when the state machine handles the ANI
collection (not related to MFCR2), you can control the state
machine to collect ANI or discard ANI.
[0] No = Don't collect ANI.
[1] Yes = Collect ANI.
[-1] Default = Default value.
Defines which Signaling System to use in both directions
(detection\generation).
[0] DTMF = Uses DTMF signaling.
[1] MF = Uses MF signaling (default).
[-1] Default = Default value.
Enables sending Wink signal toward CAS trunks.
[0] = Disable (default).
[1] = Enable.
If the device receives a mid-call SIP INFO message with
flashhook event body (as shown below) and this parameter is set
to 1, the device generates a wink signal toward the CAS trunk.
The CAS wink signal is done by changing the A bit from 1 to 0,
and then back to 1 for 450 msec.
INFO sip:4505656002@192.168.13.40:5060 SIP/2.0
Via: SIP/2.0/UDP 192.168.13.2:5060
From: <sip:06@192.168.13.2:5060>
To:
<sip:4505656002@192.168.13.40:5060>;tag=132878
796-1040067870294
Call-ID: 0010-0016-D69A7DA8-1@192.168.13.2
CSeq:2 INFO
Content-Type: application/broadsoft
Content-Length: 17
event flashhook
Note: This parameter is applicable only to T1 CAS protocols.
388
Description
Document #: LTRT-89707
Mediant 3000
Advertisement
Table of Contents
Troubleshooting
