Removing A Dvd Drive - Lenovo System x3550 M4 Installation And Service Manual

b. Gently push the drive into the bay until the drive stops.
Step 6. Reinstall the drive bay filler panel that you removed earlier.
Step 7. If you are installing additional simple-swap hard disk drives, do so now.
Step 8. Turn on the peripheral devices and the server.
Drive IDs
The drive ID that is assigned to each drive is printed on the front of the server. The following illustrations
show the locations of the IDs of the drives. The ID numbers and the drive bay numbers are the same.
2.5-inch simple-swap hard disk drive IDs
The simple-swap-drive ID that is assigned to each drive is printed on the front of the server.
The following illustration shows the location of the IDs of the hard disk drives. The ID numbers and the
drive bay numbers are the same.
Figure 123. 2.5-inch simple-swap hard disk drive IDs
3.5-inch simple-swap hard disk drive IDs
The simple-swap-drive ID that is assigned to each drive is printed on the front of the server.
The following illustration shows the location of the IDs of the hard disk drives. The ID numbers and the
drive bay numbers are the same.
Figure 124. 3.5-inch simple-swap hard disk drive IDs

Removing a DVD drive

Use this information to remove a DVD drive.
To remove an optional DVD drive, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 31.
Step 2. Turn off the server and peripheral devices and disconnect all power cords.
Step 3. Remove the server cover (see "Removing the cover" on page 189).
204
System x3550 M4 Installation and Service Guide