Lenovo System x3550 M4 Installation And Service Manual page 67

Table 10. Adapter configurations (continued)
Description
Qlogic 8200 dual-port 10GbE SFP+ VFA
ServeRAID M5120 SAS/SATA controller
ServeRAID M5225 SAS/SATA controller
Solarflare SFN5162F midrange dual-port
10GbE SFP+ adapter
Solarflare SFN6122F low latency dual-port
10GbE SFP+ adapter
Solarflare SFN7122F 2x10GbE SFP+ flareon
ultra adapter for System x
1. You can purchase System x3550 M4 Thermal Solution Kit (option part number 00Y7117) to acquire two
additional fans for your server.
• Any high-definition video-out connector or stereo connector on any add-on video adapter is not supported
• The server does not support full-length, full-height PCI adapters or legacy 5V PCI adapters.
• When you install any PCI adapter, the power cords must be disconnected from the power source before
you remove the PCI Express riser-card assembly and the PCI-X riser-card assembly. Otherwise, the
active power management event signal will be disabled by the system-board logic, and the Wake on LAN
feature might not work. However, after the server is powered-on locally, the active power manager active
power management event signal will be enabled by the system-board logic.
• The server provides two PCI riser-card slots on the system board. The following information describes the
PCI riser-card slots and the type of adapters that the riser cards support:
– If you want to install a PCI Express or PCI-X adapter, you must order the PCI riser-card option.
– PCI riser slot 1. This slot supports only low-profile adapters.
– PCI riser slot 2. This slot supports full-height, half-length adapters.
The following table lists the supported configurations for the PCI riser-card slots.
Table 11. PCI riser slots supported configurations
PCI riser-card
slot number Configuration 1
Slot 1 PCI Express 3.0 (x16) card
with a PCI Express riser card
with a standard bracket
Slot 2 PCI Express 3.0 (x8) card with
a PCI Express riser card with
a standard bracket
Notes:
1. The instructions in this section apply to any PCI adapter (for example, video graphics adapters or
network adapters).
2. Do not set the maximum digital video adapter resolution above 1600 x 1200 at 75 Hz for an LCD monitor.
This is the highest resolution that is supported for any add-on video adapter that you install in the server.
Option part
number PCI riser 1
90Y4600 Six fans installed
1
required
81Y4478 Six fans installed
1
required
00AE938 Not supported
47C9952 Six fans installed
1
required
47C9960 Six fans installed
1
required
47C9977 Six fans installed
1
required
Configuration 2 (Two
microprocessors installed)
PCI Express 3.0 (x16) card
with a PCI Express riser card
with a standard bracket
PCI Express 3.0 (x16) card
with a PCI Express riser card
with a standard bracket
PCI riser 2
Six fans installed
1
required
Six fans installed
1
required
Four fans installed
required
Six fans installed
1
required
Six fans installed
1
required
Six fans installed
1
required
Configuration 3
PCI Express 3.0 (x16) card
with a PCI Express riser card
with a standard bracket
PCI-X 64-bit/133 MHz card
with a PCI-X riser card with a
standard bracket
.
Chapter 2 Installing optional devices
53