Dsa System Management Test Results; Test Results For The Dsa System Management Test - Lenovo System x3550 M4 Installation And Service Manual

User Response
Complete the following steps:
1. Insert a new CD or DVD into the drive and wait for 15 seconds for the media to be recognized.
Rerun the test.
2. Check the drive cabling for loose or broken connections at both ends or damage to the cable.
Replace the cable if damage is present.
3. Run the test again.
4. Check system firmware level and upgrade if necessary.The installed firmware level can be found
in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
5. Run the test again.
6. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service
Guide" for the next corrective action.
Related links
– IBM Support website
– Latest level of DSA
– Latest level of BMC/IMM

DSA system management test results

The following messages can result when you run the system management test.

Test results for the DSA system management test

The following messages can result when you run the DSA system management test.
• 166-000-001 : IMM I2C Test Passed
IMM I2C Test Passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
No
Related links
– IBM Support website
– Latest level of DSA
– Latest level of BMC/IMM
• 166-801-001 : IMM I2C Test Aborted
Appendix C. DSA diagnostic test results
951