8. Connect any needed cables to the adapter.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 97.
Removing the DVD drive
To remove the DVD drive 1 , do the following:
1. Read the safety information that begins on page vii and "Handling
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Unlock and remove the left-side cover (see "Removing the left-side cover" on
4. Disconnect the DVD drive cables from the back of the DVD drive.
5. Open the bezel (see "Opening the bezel" on page 41).
6. Grasping the blue tabs on each side of the DVD drive, press them inward while
7. Remove the rails from the DVD drive and save them for future use.
8. If you are instructed to return the DVD drive, follow all packaging instructions,
Attention:
Incomplete insertion might cause damage to the system board or
the adapter.
static-sensitive devices" on page 39.
all external cables.
page 42).
you pull the drive out of the sever.
and use any packaging materials for shipping that are supplied to you.
Chapter 5. Installing optional devices and replacing customer replaceable units
75