Configuring A Vpws - Zte ZXR10 5900E series Configuration Manual

Such Layer 2 transparent transmission based on MPLS changes traditional confinement
that Layer 2 link should be implemented through network switch. It essentially forms a
pattern of One Net Multi-Service pattern and makes the operator provide Layer 2 and Layer
3 Services simultaneously in a MPLS net.

2.3.2 Configuring a VPWS

To configure an PWS on the ZXR10 5900E, perform the following steps:
Step Command
1
ZXR10(config)#
2
ZXR10(config-vpws-zte)#
ZXR10(config-vpws-zte)#
ZXR10(config-vpws-zte)#
3
ZXR10(config-vpws-zte-ac-vlan2)#
ethernet
4
ZXR10(config-vpws-zte)#
5
ZXR10(config)#
ZXR10(config)#
ZXR10(config-vpws-zte)#
ZXR10(config-vpws-zte-pw-pw1)#
<ipv4-address>[ vcid <1-4294967295>]
ZXR10(config-vpws-zte-pw-pw1)#
ZXR10(config-vpws-zte-pw-pw1-rm)#
{1+1|1:1}{bidirectional|unidirectional}[receiving
{selective|both}] protect-strategy {aps|mc-aps
{master|backup}}
ZXR10(config-vpws-zte-pw-pw1-rm)#
ZXR10(config-vpws-zte-pw-pw1)#
ZXR10(config-vpws-zte)#
<pw-name>
SJ-20150114102049-016|2015-03-10 (R1.0)
vpws <instance-name>
access-point <interface-name>
description<description>
mtu <mtu>
access-params
pseudo-wire <pw-name>
pw pw1
vpws zte
pseudo-wire pw1
neighbour
redundancy-manager
protect-type
exit
exit
backup-pw <pw-name> protect
2-21
Chapter 2 MPLS L2VPN Configuration
Function
Creates a VPWS instance.
Configures the binding
relationship between the
AC interface and the VPWS
instance.
Configures the description
information for the VPWS
instance.
Configures the maximum
transfer unit for the VPWS
instance.
Sets the AC interface type to
ethernet.
Configures the binding
relationship between the
PW interface and the VPWS
instance.
Configures the PW.
Configures the protected
capability for the PW.
Configures the redundancy
protection mode for the PW.
Configures the standby PW and
protection relationship.
ZTE Proprietary and Confidential