Maintaining Mpls Vpn - Zte ZXR10 5900E series Configuration Manual

PE1(config-bgp-af-ipv4-vrf)#redistribute connected
PE2 configuration,
PE2(config)#ip vrf ok
PE2(config-vrf-ok)#rd 1:1
PE2(config-vrf-ok)#address-family ipv4
PE2(config-vrf-ok-af-ipv4)#route-target 1:1
PE2(config-vrf-ok-af-ipv4)#exit
PE2(config-vrf-ok)#exit
PE2(config)#router bgp 65190
PE2(config-bgp)#neighbor 61.139.36.31
PE2(config-bgp)#neighbor 61.139.36.31 update-source loopback1
PE2(config-bgp)#address-family vpnv4
PE2(config-bgp-af-vpnv4)#neighbor 61.139.36.31 active
PE2(config-bgp-af-vpnv4)#exit
PE2(config-bgp)#exit
PE2(config)#interface loopback20
PE2(config-if-loopback20)#ip vrf forwarding ok
PE2(config-if-loopback20)#ip address 20.20.20.20 255.255.0.0
PE2(config-if-loopback20)#exit
PE2(config)#router bgp 65190
PE2(config-bgp)#address-family ipv4 vrf ok
PE2(config-bgp-af-ipv4-vrf)#redistribute connected
l Configuration Check
View the route learning from PE2 on PE1,
PE1#show ip protocol routing vrf ok
Routes of vpn:
status codes: *valid, >best, s-stale
Dest
*>20.20.0.0/16
View the route learning from PE1 on PE2,
PE2#show ip protocol routing vrf ok
Routes of vpn:
status codes: *valid, >best, s-stale
Dest
*>10.10.0.0/16

1.1.3 Maintaining MPLS VPN

To maintain MPLS VPN, use the following commands on ZXR10 5900E.
SJ-20150114102049-016|2015-03-10 (R1.0)
NextHop Intag Outtag
20.1.2.2 163898 34
NextHop Intag Outtag
30.1.2.1 164963 163863
1-17
Chapter 1 MPLS L3VPN Configuration
remote-as 65190
RtPrf Protocol
200 bgp-int
RtPrf Protocol
200 bgp-int
ZTE Proprietary and Confidential