Zte ZXR10 5900E series Configuration Manual page 69

local-description
remote-description : ??
For a description of the parameters in the execution result, refer to the following table:
show Command Output
PW entity
LSPs formed
C-bits
local
remote
negotiated
Labels
local
remote
negotiated
Configured
Received
Negotiated
Sent
AC ready
application
service-type
instance-id
LDP session
attachment-circuit
local-description
remote-description
oam status
redundancy
The following is sample output from the show pwe3 signal statistics command:
ZXR10(config)#show pwe3 signal statistics
The statistics of dynamic PWs or PW-segments:
Headers : APP - application instance of PW,
SJ-20150114102049-016|2015-03-10 (R1.0)
: vlan200
Description
Address, VCID, and PW type of the peer end
Whether it is used on the data layer
Control word information
Whether the local end supports the CWORD
Whether the peer end supports the CWORD
Whether the negotiation result shows that the CWORD is
supported
Tag information
Local tag value
Remote tag value
Signalling status
Whether the PW interface is configured
Whether the peer mapping message is received
Whether the signalling negotiation is successful
Whether local end sends a mapping message to the peer end
Whether the binding interface is in up status (for VPWS)
Application information
Application type
VPN instance ID
LDP session state
Name of the binding interface (VPWS binding interface)
Description of the local interface (interface name)
Description of the remote interface
Remote OAM status, PSN status, and AC status
PW redundancy forwarding status
C-bit - the PWs using control word,
ether - the ethernet raw PWs,
Chapter 2 MPLS L2VPN Configuration
2-15
ZTE Proprietary and Confidential