Zte ZXR10 5900E series Configuration Manual page 73

PE2(config-vlan)#exit
PE2(config)#
PE2(config)#mpls ldp instance 1
PE2(config-ldp-1)#interface vlan100
PE2(config-ldp-1-if-vlan100)#$
PE2(config-ldp-1)#router-id loopback1
PE2(config-ldp-1)#$
PE2(config)#mpls l2vpn enable
PE2(config)#pw pw1
PE2(config)#vpls 128
PE2(config-vpls-128)#access-point gei-0/1/1/1.1
PE2(config-vpls-128-ac-gei-0/1/1/1.1)#access-params ethernet
PE2(config-vpls-128-ac-gei-0/1/1/1.1-eth)#$
PE2(config-vpls-128-ac-gei-0/1/1/1.1)#$
PE2(config-vpls-128)#pseudo-wire pw1
PE2(config-vpls-128-pw-pw1)#neighbour 206.206.206.206 vcid 1
PE2(config-vpls-128-pw-pw1-neighbour)#$
PE2(config-vpls-128-pw-pw1)#$
PE2(config-vpls-128)#$
PE2(config)#mpls interface vlan100
PE2(config)#$
Configuration Verification
After the configuration, a VPLS PW can be established successfully. The following
information shows the result of configuration check.
PE1:
PE1(config-vpls-test)#show l2vpn forwardinfo
Headers: PWType - Pseudo Wire type and Pseudo Wire connection mode
Llabel - Local label, Rlabel - Remote label
VPNowner - Owner type and instance name
Codes : H - HUB mode, S - SPOKE mode, L - VPLS, W - VPWS, M - MSPW
$pw - auto_pw
PWName PeerIP
pw1 1.1.1.2
pw2 1.1.1.2
PE1(config)#show l2vpn summary
The summary information about configured L2VPN:
vpn type
VPLS
VPWS
MSPW
VLSS
SJ-20150114102049-016|2015-03-10 (R1.0)
FEC PWType State Llabel
128 Ethernet S UP
128 Ethernet S UP
configure/maximum
1/4095
0/4095
0/8192
0/8000
2-19
Chapter 2 MPLS L2VPN Configuration
Rlabel VPNowner
81920 81920 L:test
81921 81921 L:test
ZTE Proprietary and Confidential