Zte ZXR10 5900E series Configuration Manual page 50

ZXR10 5900E Series Configuration Guide (VPN)
Use show bgp vpnv4 unicast vrf zte summary on PE1 to view whether the neighborhood
between PE1 and CE1 is established.
2. Configure the maximum value of VRF zte routes is 100 on PE1, and the route alarm
threshold value is 60%.
PE1(config)#ip vrf zte
PE1(config-vrf-zte)#address-family ipv4
PE1(config-vrf-zte-af-ipv4)#maximum routes 100 60
Use show ip vrf detail zte to view the configuration result of maximum routes.
Enable alarm and terminal monitor functions on PE1 to view the alarm if the number
of routes exceeds the threshold.
PE1#terminal monitor
PE1#configure terminal
PE1(config)#logging on
3. CE1 advertises 50 EBGP route entries to PE1 (it does not exceed the 60% of alarm
threshold value). Use show ip protocol routing vrf zte to view the 50 VRF EBGP route
entries on PE1. PE1 does not give any alarm.
4. CE1 continues to advertise 20 EBGP route entries to PE1. There are 70 EBGP route
entries now (It exceeds 60% of alarm threshold value). Use show ip protocol routing
vrf-summary zte on PE1 to view the 70 VRF EBGP route entries. PE1 gives an alarm.
PE1(config)#show ip protocol routing vrf-summary zte
VRF
connected:
static:
ospf:
rip:
bgp:
isis:
icmp:
snmp:
nat:
natpt:
vrrp:
ppp:
asbr_vpn:
rsvpte:
usr-ipaddr:
usr-net:
ipsec:
ps-user:
ps-busi:
ves:
ldp:
user-special:
SJ-20150114102049-016|2015-03-10 (R1.0)
Source Count
4
0
0
0
1
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
1-44
ZTE Proprietary and Confidential