Vpn Route Alarm Configuration Example; Chapter 2 Mpls L2Vpn Configuration; Figure 1-11 Vpn Route Alarm Configuration Example Topology - Zte ZXR10 5900E series Configuration Manual

Export route-map: 3
Mpls label mode:
ipv4 VRF label allocation mode: per-vrf
ipv6 VRF label allocation mode: per-prefix
per-vrf inlabel:
Interface:
vlan10
vlan21
vlan501
Parameter descriptions are as follows:
Show Command output
Export VPN route-target
communities
Import VPN route-target
communities

1.3.4 VPN Route Alarm Configuration Example

Configuration Description
As shown in
on PE1, and its both of its RT and RD is 1:1. The interface int 1 is bound to VRF zte.
The IP address of int 1 is 10.1.1.1/24, and that of port 1 is 10.1.1.2/24. CE1 accesses to
PE1 through EBGP.

Figure 1-11 VPN Route Alarm Configuration Example Topology

Configuration Process
1. To establish EBGP neighborhood between PE1 and CE1, configure PE1 as follows,
PE1(config)#router bgp 100
PE1(config-bgp)#address-family ipv4 vrf zte
PE1(config-bgp-af-ipv4-vrf)#neighbor 10.1.1.2 remote-as 200
Perform the corresponding configuration on CE1 to make it establish EBGP
neighborhood between PE1.
SJ-20150114102049-016|2015-03-10 (R1.0)
213059
Description
Exports the RT attributes included in the VPN route.
Imports the RT attributes included in the VPN route.
Figure 1-11, a L3VPN network is constructed. VRF named zte is configured
Chapter 1 MPLS L3VPN Configuration
1-43
ZTE Proprietary and Confidential