Figure 1-4 Running Ebgp Between Ce And Pe - Zte ZXR10 5900E series Configuration Manual

ZXR10 5900E Series Configuration Guide (VPN)
Step Command
1
ZXR10(config)#
2
ZXR10(config-bgp)#
3
ZXR10(config-bgp-af-ipv4-vrf)#
remote-as <as-number>
Configuration Example
As shown in

Figure 1-4 Running EBGP between CE and PE

Configure BGP on CE1 and PE1 respectively. Make sure that CE1 and PE1 can distribute
route to each other.
CE1 configuration,
CE1(config)#router bgp 65001
CE1(config-bgp)#neighbor 10.1.0.2 remote-as 100
CE1(config-bgp)#neighbor 10.1.0.2 ebgp-multihop
CE1(config-bgp)#neighbor 10.1.0.2 activate
CE1(config-bgp)#redistribute connected
CE1(config-bgp)#exit
PE1 configuration,
PE1(config)#router bgp 100
SJ-20150114102049-016|2015-03-10 (R1.0)
router bgp < as-number>
address-family ipv4 vrf < vrf-name>
Figure 1-4, run EBGP between CE1 and PE1.
neighbor < ip-address>
1-12
ZTE Proprietary and Confidential
Function
This enters into BGP route
configuration mode.
This enters into the
corresponding VRF address
family configuration mode.
This configures an EBGP
neighbor or AS number of a
neighbor peers.