Zte ZXR10 5900E series Configuration Manual page 76

ZXR10 5900E Series Configuration Guide (VPN)
Step Command
ZXR10(config-vpws-zte-protect-pw2)#
<ipv4-address>[ vcid <1-4294967295>]
6
ZXR10(config-vpws-zte-pw-pw1-neighbour-1.1.1.2)#
ontrol-word preferred
ZXR10(config-vpws-zte-pw-pw1-neighbour-1.1.1.2)#
ccv bfd capability {basic|status} encapsulation {raw|ip}
ZXR10(config)#
ZXR10(config-vpws-zte-pw-pw1-neighbour-1.1.1.2)#
unnel-policy <policy-name>
ZXR10(config-vpws-zte-pw-pw1-neighbour-1.1.1.2)#
rack <track-name>
ZXR10(config-vpws-zte-pw-pw1-neighbour-1.1.1.2)#
ignal {dynamic|static local-label <16-1048575>
remote-label <16-1048575>}
For a description of the parameter in Step 1, refer to the following table:
Parameter
<instance-name>
For a description of the parameters in Step 2, refer to the following table:
Parameter
<interface-name>
<60-9216>
<description>
For a description of the parameters in Step 3, refer to the following table:
Parameter
<ethernet>
For a description of the parameters in Step 4, refer to the following table:
Parameter
<pw-name>
For a description of the parameters in Step 5, refer to the following table:
Parameter
<ipv4-address>
SJ-20150114102049-016|2015-03-10 (R1.0)
tunnel-policy <policy-name>
Description
VPWS instance name
Description
Name of the interface binding to the VPWS instance
Available number of MTUs configured for the VPWS instance
Description information about the VPN instance
Description
Sets an AC interface type to ethernet
Description
Name of the PW interface
Description
Remote LSR ID
2-22
Function
Configures the standby PW.
neighbour
Enables the use of the control
c
word for the PW.
v Enables the VCCV function for
the PW.
Configures the application
t tunnel policy for the PW.
Configures a track instance.
t
Sets the establishment mode of
s
the PW to signal triggering.
ZTE Proprietary and Confidential