Zte ZXR10 5900E series Configuration Manual page 84

ZXR10 5900E Series Configuration Guide (VPN)
ZXR10(config-if-vlan2)#exit
ZXR10(config)#mpls l2vpn enable
ZXR10(config)#vpws test
ZXR10(config-vpws-test)#mtu 100
ZXR10(config-vpws-test)#access-point vlan2
ZXR10(config-vpws-test-ac-vlan2)#access-params ethernet
ZXR10(config-vpws-test-ac-vlan2-eth)#exit
ZXR10(config-vpws-test-ac-vlan2)#exit
ZXR10(config)#pseudo-wire pw1
ZXR10(config-vpws-test-pw-pw1)#neighbour 1.1.1.1 vcid 100
ZXR10(config-vpws-test-pw-pw1-neighbour-1.1.1.1)#exit
ZXR10(config-vpws-test-pw-pw1)#exit
ZXR10(config-vpws-test)#exit
ZXR10(config)#
Configuration Verification
Run the show l2vpn forwardinfo command to verify that the VPWS PW is configured
successfully on the switch. The execution result is displayed as follows:
ZXR10(config)#show l2vpn forwardinfo
Headers: PWType - Pseudo Wire type and Pseudo Wire connection mode
Codes : H - HUB mode, S - SPOKE mode, L - VPLS, W - VPWS, M - MSPW
PWName
pw1
ZXR10(config)#show l2vpn summary
The summary information about configured L2VPN:
vpn type
VPLS
VPWS
MSPW
SJ-20150114102049-016|2015-03-10 (R1.0)
Llabel - Local label, Rlabel - Remote label
VPNowner - Owner type and instance name
$pw - auto_pw
PeerIP FEC PWType
1.1.1.2 128 Ethernet
State Llabel
UP 81920
configure/maximum
0/4095
1/4095
0/8192
2-30
ZTE Proprietary and Confidential
Rlabel VPNowner
81920 W:test