Zte ZXR10 5900E series Configuration Manual page 46

ZXR10 5900E Series Configuration Guide (VPN)
PE2(config-if-vlan3)#ip address 10.0.0.2 255.255.255.0
PE2(config-if-vlan3)#exit
PE2(config)#mpls ldp
PE2(config-ldp-1)#interface vlan3
PE2(config-ldp-1-if-vlan3)#exit
PE2(config-ldp-1)#exit
PE2(config)#mpls interface vlan3
PE2(config)#router ospf 1
PE2(config-ospfv-1)#router-id 1.1.1.2
PE2(config-ospf-1)#network 1.1.1.2 0.0.0.0 area 0.0.0.0
PE2(config-ospf-1)#network 10.0.0.0 0.0.0.255 area 0.0.0.0
PE2(config-ospf-1)#exit
PE2(config)#mpls ldp instance 1
PE2(config-ldp-1)#router-id loopback1
PE2(config-ldp-1)#exit
PE2(config)#router bgp 100
PE2(config-bgp)#neighbor 1.1.1.1 remote-as 100
PE2(config-bgp)#neighbor 1.1.1.1 update-source loopback1
PE2(config-bgp)#address-family vpnv4
PE2(config-bgp-af-vpnv4)#neighbor 1.1.1.1 activate
PE2(config-bgp-af-vpnv4)#exit
Configuration Check
View VRF routing table on PE1. Here, both the sub-routes and the aggregated route can
be viewed.
PE1(config)#show ip protocol routing
Routes of vpn:
status codes: *valid, >best, s-stale
Dest
*> 150.0.0.0/8
*> 150.1.0.0/16
*> 150.2.0.0/16
View PE2 routing table. Here, only the aggregated route can be viewed.
PE2(config)#show ip protocol routing
Routes of vpn:
status codes: *valid, >best, s-stale
Dest
*> 150.0.0.0/8
SJ-20150114102049-016|2015-03-10 (R1.0)
instance 1
vrf test1
NextHop Intag
0.0.0.0 87
20.0.0.2 86
30.0.0.2 85
vrf test1
NextHop Intag
1.1.1.1 165366
1-40
Outtag RtPrf Protocol
notag 254 bgp-aggr-discard
notag 20 bgp-ext
notag 20 bgp-ext
Outtag RtPrf Protocol
87 200 bgp-int
ZTE Proprietary and Confidential