Maintaining Vpls Instances - Zte ZXR10 5900E series Configuration Manual

For a description of the parameter in Step 3, refer to the following table:
Parameter
ethernet
For a description of the parameters in Step 4, refer to the following table:
Parameter
[<1-4294967295>]
{<ipv4-address>}
For a description of the parameters in Step 5, refer to the following table:
Parameter
<policy-name>
dynamic
static
<16-1048575>
tagged
raw
For a description of the parameter in Step 6, refer to the following table:
Parameter
<pw-name>

2.2.3 Maintaining VPLS Instances

To maintain VPLS instances on the ZXR10 5900E, run the following commands:
Command
show l2vpn brief
ZXR10#
show l2vpn summary
ZXR10#
show l2vpn forwardinfo {[vpnname
ZXR10#
<instance-name>]|[peer <ipv4-address>]}[detail]
show pwe3 signal
ZXR10#
show pwe3 signal fec128 {detail [local-label
ZXR10#
<16-1048575>| peer <peerip>]
SJ-20150114102049-016|2015-03-10 (R1.0)
Chapter 2 MPLS L2VPN Configuration
Description
Sets ACs type to ethernet
Description
VC ID
LSR ID of the remote PE
Description
Name of the tunnel policy
PW type is dynamic
PW type is static
Range of the PW label
PW uses Tagged mode
PW uses Raw mode
Description
PW name
Function
Displays the list of L2VPN instances and the
number of AC and PW interfaces bound to
L2VPN instances.
Displays the number of L2VPN instances.
Displays the valid PW list in accordance with
the instance name.
Displays the brief information about the PW.
Displays the detailed information of the PW.
2-11
ZTE Proprietary and Confidential