Configuring Ebgp Between Ce And Pe - Zte ZXR10 8900 Series User Manual

ZXR10 8900 Series User Manual (MPLS Volume)
St- Command
ep
1
ZXR10(config)#
2
ZXR10(config-router)#
<vpn-name>
3
ZXR10(config-router-af)#
remote-as <as-number>
4
ZXR10(config-router-af)#
5
ZXR10(config-router-af)#
Example
42 Confidential and Proprietary Information of ZTE CORPORATION
The result shows that CE1 has learned route from CE2 through
OSPF.
Route information on CE2 is shown below.
CE2#show ip route ospf
IPv4 Routing Table:
Dest Mask
10.1.0.0 255.255.255.252 10.2.0.2
10.1.1.0 255.255.255.0
The result shows that CE2 has learned route from CE1 through
OSPF.
CE1 can ping to the LAN connecting to CE2 successfully, as shown
below.
CE1#ping 10.2.1.1
sending 5,100-byte ICMP echos to 10.2.1.1,timeout is 2 seconds.
!!!!!
Success rate is 100 percent(5/5),round-trip min/avg/max= 0/0/10
CE2 can ping to the LAN connecting to CE1 successfully, as shown
below.
CE2#ping 10.1.1.1
sending 5,100-byte ICMP echos to 10.1.1.1,timeout is 2 seconds.
!!!!!
Success rate is 100 percent(5/5),round-trip min/avg/max= 0/0/10
Configuring EBGP between CE and
PE
To configure EBGP between a CE and a PE, perform the following
steps.
router bgp <as-number>
address-family ipv4 vrf
neighbor <ip-address>
redistribute connected
exit-address-family
This example shows how to configure EBGP between CE1 and PE1,
as shown in Figure
Gw Interface Owner
fei_1/1
10.2.0.2 fei_1/2
Function
This enters BGP route
configuration mode
This enters IPv4 address
family configuration mode
This configures an EBGP peer
This redistributes direct route
to BGP
This exits IPv4 address family
configuration mode
24.
pri metric
ospf 110 1
ospf 110 1