Configuring Ospfv3; Table 7-1 Similarities And Differences Between Ospfv3 Lsas And Ospfv2 Lsas - Zte ZXR10 5900E Configuration Manual

Table 7-1 Similarities and Differences Between OSPFv3 LSAs and OSPFv2 LSAs

OSPFv2 LSA
Router LSA
Network LSA
Network Summary LSA
ASBR Summary LSA
AS External LSA
-

7.2 Configuring OSPFv3

Enabling OSPFv3
To enable OSPFv3, perform the following steps.
Step Command
1
ZXR10(config)#
2
ZXR10(config-ospfv3-process-id)#
<router-id>
Configuring OSPFv3 Interface Attributes
To configure OSPFv3 interface attributes, perform the following steps.
Step Command
1
ZXR10(config)#
2
ZXR10(config-ospfv3-process-id)#
<interface-name>[area <area-id>] nstance <0-255>]
SJ-20150114102049-011|2015-01-15 (R1.0)
OSPFv3 LSA
Router LSA
Network LSA
Inter Area Prefix LSA
Inter Area Router LSA
AS External LSA
Link LSA
Intra Area Prefix LSA
ipv6 router ospf <process-id>
router-id
ipv6 router ospf<process-id>
interface
7-5
Chapter 7 OSPFv3 Configuration
Similarities with and
Differences from OSPFv2
LSAs
The name is the same and the
function is similar, except that
the LSA no longer describes
address information but is used
only to describe the topology
structure of the routing area.
The function is similar but the
name is different.
Both the function and the name
are completely the same.
The LSA is newly added.
The LSA is newly added.
Function
Enables the OSPFv3 process.
Specifies the Router ID for an
OSPFv3 process.
Function
Enters the interface
configuration mode.
Adds an interface to OSPFv3.
ZTE Proprietary and Confidential