Cutting Equipment - Partner K 650/700 Active Workshop Manual

A
C
C
D

Cutting equipment

Release the belt tension and dismantle
the front belt guard and cutter arm.
B
Dismantle the clutch cover and drive belt.
Dismantle the pulley from the cutter arm.
Press out the shaft by means of a mandrel
and hammer.
NOTE!
If only the arbor bush and flange are to be
dismantled this can be done by levering
with two screw drivers placed between
the flange and guard.
Unscrew the nuts (A).
Screw out the tensioning screw (B) so
that the belt tension releases.
Remove the belt guard and cutter arm.
Remove the nuts (C) and screw (D).
Lift off clutch cover and drivebelt.
Lock the pulley with a suitable locking pin
and unscrew the screw which holds the
pulley.
Lift off the pulley and washer which lies
between the ball bearings and pulley.
Place a suitable sleeve under the cutter
arm and press out the shaft by means of
a drift and hammer.
Lift off the spacer sleeve and support
washer.
NOTE!
If only the spacer sleeve and support
washer are to be dismantled this can be
done by bending with two screwdrivers
placed between the washer and guard.
Thereafter bend away the support was-
her and sleeve.
7
79