Partner K 650/700 Active Workshop Manual page 10

Max
+1/2
Starter unit
Tension the return spring.
Check that the spring tension is completely
released, and lift the starter cord up into
the cut-out in the pulley.
Wind the pulley 7 turns clockwise.
Pull the cord out completely and check
that the pulley can be turned at least a
further half turn.
Mod. 1250
Press a new return spring down in the
starter unit cover.
Lubricate the spring with a few drops of
oil.
Anchor the cord in the pulley.
Push the pulley down onto the shaft jour-
nal.
Tension the return spring.
1. Check that spring tension is competely
released.
2. Lift the starter cord up into the cut-out
in the pulley.
3. Wind the pulley 7 turns clockwise.
Be careful and brake the pulley with
your thumb.
4. Pull the cord out completely and check
that the pulley can be turned at least
a further half turn.
Mod. 1250
Press down a new return spring in the
starter unit cover.
NOTE!
Do not remove the lock round the spring,
but push down the spring all round by
using your thumbs.
Lubricate the spring with a few drops of
oil.
Anchor the starter cord round the hub of
the pulley as shown in the diagram.
Push the cord wheel down on the shaft
journal in the starter unit housing.
Make sure that the spring grips the cord
wheel.
Lubricate the bearing with a few drops of
oil.
1
9