Partner K 650/700 Active Workshop Manual page 37

3
36
Fuel system
Lift off the half of the grip and the throttle
control.
Note the washer under the throttle control
and the sleeve inside the control.
Hook in the spring in the hole in the
throttle control and move it to the correct
position opposite the screw hole.
Lock the throttle control with the catch
and insert the screw in the throttle control's
supporting sleeve.
Lift off the half of the grip.
NOTE!
One end of the return spring for the throttle
control catch goes in the hole on the
throttle control.
Lift off the throttle control. Note the was-
her under the throttle control and the
sleeve inside the control so that they are
not lost during cleaning.
Fit in the reverse order to dismantling.
Replace damaged or worn parts.
Fit all parts in the left-hand half of the grip.
1. Place the spring for the throttle control
catch in position round the pin with the
hole in it.
2. Place the throttle control catch in po-
sition.
3. Push the sleeve in the throttle control
from underneath.
4. Hold the sleeve in position with your
forefinger and hook the spring in the
hole in the throttle control.
5. Move the throttle control to the correct
position opposite the screw hole.
6. Press in the start throttle catch and
lock the throttle control in start posi-
tion.
7. Insert the screw in the throttle control's
supporting sleeve.