Carburettor, Dismantling/Assembly - Partner K 650/700 Active Workshop Manual

4
2
3
Fuel system
Carburettor
Dismantling, all models
Dismantle all covers and air filters so that
the carburettor becomes accessible.
Blow clean the carburettor chamber with
compressed air.
Mod. 650, 700
Remove the screw guide and lock was-
her which holds the throttle push rod at
the lever.
Remove the fuel hose.
Release the carburettor screws and lift
off the carburettor together with the choke
control, air filter connection, and middle
piece.
502 50 18-01
Carburettor
Mod. 950
Blow clean the carburettor area with
compressed air before the carburettor is
1 removed.
Carburettor
Dismantling, all models
Dismantle all covers and air filters so that
the carburettor becomes accessible.
Close the choke flap to prevent dirt pene-
trating into the engine.
Blow clean the carburettor chamber with
compressed air.
Mod. 650, 700
1. Remove the screw guide from the
carburettor's adjusting screws.
2. Bend away the lock washer which
holds the throttle push rod at the lever
by means of a screwdriver.
NOTE!
EPA-models have fixed jets and conse-
quently do not have screwdriver guides.
3. Remove the fuel hose from the car-
burettor.
4. Unscrew the carburettor screws. Insert
hex key 502 50 18-01 through the
hole in the stop control when the left
screw is to be unscrewed.
5. Lift off the carburettor together with
the choke control, air filter connection
and middle piece.
For service procedures see "Disassembly
of carburettor".
Carburettor
Mod. 950
Dismantle all covers and air filter. Blow
clean the carburettor area with
compressed air.
Dismantle the following:
1. Impulse hose
2. Fuel hose
3. Choke lever
4. Throttle lever (from throttle control)
3
23