Partner K 650/700 Active Workshop Manual page 45

4
Min. 1 mm
44
Centrifugal clutch
Mod. 950, 1250
Dismantle all the cutting equipment and
unscrew the plug.
Fit piston stop No. 502 54 15-01 and
dismantle the clutch clockwise.
502 54 15-01
Remove the clutch springs with a small
screwdriver.
Clean and inspect the clutch parts for
damage and wear.
Inspect the clutch drum for wear on the
mating surfaces for the centrifugal clutch
and drive belt.
Mod. 950, 1250
Dismantle the front and rear belt covers,
cutter arm with cutter disc and drive belt.
Remove the air filter covers and air filter,
and remove the plug.
Fit the piston stop No. 502 54 15-01 in the
plug hole and dismantle the clutch
clockwise.
Remove the clutch springs with a small
screwdriver.
Clean and inspect the clutch hub spokes
and the clutch shoes for wear.
There must be at least 1 mm of material
left at the most worn part of the clutch
shoes.
All the shoes must be replaced at the
same time.
Inspect the clutch drum for wear on the
mating surfaces for the centrifugal clutch
and drive belt.
The inner diameter of the clutch drum
must not exceed 79.8 mm.
Replace worn parts.