Partner K 650/700 Active Workshop Manual page 71

6
M5 x 20 mm
503 27 35-99
A
B
70
Crankshaft and crankcase
Pull the repair bushing into place with an M5 screw and washer as shown in
theillustration.
NOTE!
Align the bushing correctly, so that the chamfered section faces the cylinder plane.
Mod. 950
Remove all screws which hold the crank-
case halves together.
Separate and fit the crankcase halves in
same way as described for mod. 650,
700.
502 51 61-01
Mod. 1250
Dismantle the cutter arm.
Mod. 950
Dismantle all parts so that only the
crankcase and crankshaft remain.
Remove all screws (9 items) which hold
the two crankcase halves together.
Separate and assemble the crankcase
halves in the same way as described for
mod. 650, 700.
Inspect the crankshaft (see chapter
"Inspection of crankshaft").
Use tool 502 50 30-08 to assemble.
Use protective sleeve No. 502 50 52-01
when the seal ring on the clutch side is
installed.
502 50 30-08
Mod. 1250
Dismantle all parts so that only the
crankcase with crankshaft remain.
Dismantle the cutter arm by removing the
nut (A) and screws (B).