Partner K 650/700 Active Workshop Manual page 15

2
A
B
0,3 – 0,5 mm
14
Ignition system
Check the ignition cable's connections.
Grease the cable ends before fitting.
Check the other cables and connections.
Check the air gap.
502 51 34-06
Still no spark?
Check the plug connection.
Pull off the rubber protection at the plug
(A) and ignition module (B) and check
that the ignition cable is undamaged. If
necessary cut off a piece of the cable to
ensure good contact.
Grease the cable ends to simplify fitting
and to prevent moisture penetrating into
the connections.
Still no spark?
Check the other cables and connections
for poor contact (dirt, corrosion, cable
break and damaged insulation).
Tips!
Use an Ohm meter to check if there is a
cable break, e.g. as a result of pinching.
Still no spark?
Check the air gap between the flywheel
magnet and ignition module. The gap
should be 0.3 – 0.5 mm (0.012–0.020").
Use air gap measure 502 51 34-06.