Partner K 650/700 Active Workshop Manual page 39

3
38
Fuel system
Mod. 1250
Separate the tank unit and crankcase,
and press off the three bearing pins.
Press the safety catches forwards/
downwards and lift them up at the back
edge.
Pull the throttle control forwards and out
of the rear grip.
Inspect the different parts and replace
those which are damaged or worn.
Mod. 1250
Separate the tank unit and crankcase.
(Where appropriate see chapter on vi-
bration damper.)
Press off the three bearing pins with a
suitable punch (Ø 2.5 mm).
Press down the safety catch, and press it
forwards (where appropriate with a small
screwdriver) so that it can be lifted up at
the back edge.
Pull the throttle control forwards, out from
the rear grip. To simplify dismantling,
press with a small screwdriver on the
lever which the throttle wire is attached
to.
Inspect the different parts and replace
damaged or worn parts with new ones.
TIP!
Bend the end of the spring to a closed
loop. This simplifies fitting and prevents
the spring from being pressed out from
the recess at the hole where the spring
should slide freely.