Partner K 650/700 Active Workshop Manual page 82

Cutting equipment
D E F
G
C
Press the shaft in through the ball bearings
until it projects 5.5 mm from the ball
bearing on the other side.
Fit the belt wheel (reinforcement washer
turned inwards). Do not forget the spacer
ring against the ball bearings.
Tighten the screw.
Turn the guard while the other parts are
held in place.
Then install a plastic washer (C), the thin
rubber washer (D), plastic washer (E),
cover plate (F) and plastic cover (G).
Tighten the three screws and check that
the guard can be turned.
505 38 13-08
Drive the shaft in through the ball bearings,
using a plastic-faced hammer, until it
projects 5.5 mm from the ball bearing on
the other side.
Fit the pulley.
Place the spacer ring on the ball bearings
and then put on the pulley with the welded
reinforcement washer turned inwards
towards the cutter arm.
Tighten the screw.
Fit the spacer sleeves and support was-
her as shown in the illustration.
Heat the spacer sleeve outside the sup-
port washer with a hot air gun to approx.
150°C to simplify fitting it on the shaft.
Press it down with a suitable drift
(502 50 82-01).
502 50 82-01
7
81